Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
Using moulding remover A, detach the 3 claws and remove the bezel plug.
REMOVE ASSIST GRIP COVER LH
Using moulding remover A, detach the 10 claws and remove the assist grip cover.
REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
Using moulding remover A, detach the 6 claws and the clip.
Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.
REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
Insert clip remover between the plate and trim board.
Turn the handle counterclockwise to remove the snap ring and handle.
REMOVE REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)
Remove the inside handle plate.
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
Remove the 3 screws.
Using a clip remover, detach the 8 clips.
*1 | w/ Rear Door Sunshade |
*2 | w/o Rear Door Sunshade |
Pull out the rear door trim board in the direction indicated by the arrow.
for 11 Speakers:
Disconnect the connector.
Disconnect the 2 cables from the inside handle.
REMOVE REAR INNER DOOR GLASS WEATHERSTRIP LH
Remove the inner glass weatherstrip by pulling it upward in the direction indicated by the arrow in the illustration.
REMOVE REAR DOOR SERVICE HOLE COVER LH
Disconnect connector and remove the service hole cover.
Tech Tips
Remove the remaining tape on the door.
REMOVE REAR DOOR GLASS RUN LH
Remove the rear door glass run.
REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
Remove the screw.
Remove the 2 bolts and rear door window division bar sub-assembly.
REMOVE REAR DOOR QUARTER WINDOW GLASS LH
Remove the rear door quarter window glass and rear door quarter window weatherstrip as a unit as shown in the illustration.
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.
Note
Do not damage the door glass.
REMOVE REAR DOOR LOCK ASSEMBLY LH
Detach the clamp.
Using a T30 "TORX" wrench, remove the 3 screws.
Move the rear door lock assembly downward, pull the release plate out of the rear door outside handle frame, and remove the rear door lock assembly and cables as a unit.
Remove the door lock wiring harness seal from the rear door lock assembly.
REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
Using a screwdriver, detach the claw.
Tech Tips
Tape the screwdriver tip before use.
Remove the rear door remote control cable.
REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH
Using a screwdriver, detach the 3 claws.
Tech Tips
Tape the screwdriver tip before use.
Remove the rear door inside locking cable.