INSTALL HEATER PUMP ASSEMBLY
Install the heater pump assembly with the nut.
Connect the 2 fuel hoses as shown in the illustration.
Using pliers, grip the claws of the clips and slide the 2 clips.
Connect the connector.
*1 | Paint Mark | *2 | 0 to -3 mm (0 to -1.18 in.) |
INSTALL COWL TOP OUTER PANEL
Install the cowl top panel with the 9 bolts.
INSTALL DIFFERENTIAL PRESSURE SENSOR ASSEMBLY (for DPF)
Connect the 2 vacuum hoses.
Note
Connect the vacuum hoses so that the painted marks of the 2 vacuum hoses are as shown in the illustration.
Install the sensor with the bolt.
Connect the sensor connector and attach the wire harness clamp.
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
Move the wiper motor and link in the direction shown by the arrow in the illustration to attach the wiper cushion to the body and install the wiper motor and link.
Install the 2 bolts.
Connect the connector and attach the clamp to install the wire harness to the cowl top panel.
INSTALL COWL TOP VENTILATOR LOUVER LH
Attach the 6 claws and 5 guides to install the cowl top ventilator louver LH.
Install the clip.
Attach the 2 claws and 2 guides to install the center cowl top ventilator louver.
INSTALL COWL TOP VENTILATOR LOUVER RH
Attach the 4 claws and 5 guides to install the cowl top ventilator louver RH.
Install the clip.
INSTALL HOOD TO COWL TOP SEAL
Attach the 7 clips and 2 claws to install the hood to cowl top seal.
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH
Operate the wiper and stop the front wiper motor and link at the automatic stop position.
*1 | Wiper Arm Serrations |
*2 | Wire Brush |
*3 | Wiper Pivot Serrations |
Clean the wiper arm serrations.
When reusing the front wiper motor and link assembly:
Clean the wiper pivot serrations with a wire brush.
*1 | Mark for Blade Position |
Position the blade tip within the range shown in the illustration.
Tech Tips
The lower limit of the range is indicated by the mark on the glass.
Install the front wiper arm and blade assembly LH with the nut.
Tech Tips
Hold the arm hinge by hand when tightening the nut.
Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and the wipers do not come into contact with the vehicle body.
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH
Operate the wiper and stop the front wiper motor and link at the automatic stop position.
*1 | Wiper Arm Serrations |
*2 | Wire Brush |
*3 | Wiper Pivot Serrations |
Clean the wiper arm serrations.
When reusing the front wiper motor and link assembly:
Clean the wiper pivot serrations with a wire brush.
*1 | Mark for Blade Position |
Position the blade tip within the range shown in the illustration.
Tech Tips
The lower limit of the range is indicated by the mark on the glass.
Install the front wiper arm and blade assembly RH with the nut.
Tech Tips
Hold the arm hinge by hand when tightening the nut.
INSTALL FRONT WIPER ARM HEAD CAP
Install the front wiper arm head cap.
Tech Tips
Use the same procedure for all front wiper arm head caps.
INSTALL NO. 1 ENGINE COVER
Attach the 4 clips to install the No. 1 engine cover.