REMOVE REAR DECK FLOOR BOX (w/ Air Suspension)
Remove the 3 clips and the rear deck floor box.
PRECAUTION (w/ Navigation System for HDD)
Note
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.
Specification | Waiting Time |
---|---|
w/o Telematics transceiver | 60 sec. |
w/ Telematics transceiver | 120 sec. |
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Air Suspension)
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE INSTRUMENT PANEL GARNISH LH
Using moulding remover B, disengage the 6 clips and remove the instrument panel garnish LH as shown in the illustration.
REMOVE NO. 1 SWITCH HOLE BASE
Push the No. 1 switch hole base in the direction indicated by the arrow to disengage the 4 claws and 2 guides.
Disconnect each connector and remove the No. 1 switch hole base.
REMOVE FUEL LID OPENER SWITCH
Disengage the 2 claws and remove the fuel lid opener switch as shown in the illustration.