DESCRIPTION
The side collision sensor LH circuit (to determine deployment of the front seat airbag assembly LH, rear seat airbag assembly LH, curtain shield airbag assembly LH and front seat outer belt assembly LH) is composed of the airbag sensor assembly, side airbag sensor assembly LH, side No. 2 airbag sensor assembly LH and door side airbag sensor LH.
The side airbag sensor assembly LH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbag and pretensioner should be deployed.
DTC B1625/22 is stored when a malfunction is detected in the side airbag sensor assembly LH.
DTC No. | DTC Detection Condition | Trouble Area |
---|---|---|
B1625/22 |
|
|
WIRING DIAGRAM
Refer to DTCs B1627/82, B1628/82, B1637/82, B1638/82, B1647/82, B1697/82 and B1698/82 Click here.
INSPECTION PROCEDURE
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.
PROCEDURE
CHECK SIDE AIRBAG SENSOR ASSEMBLY LH
Turn the power switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Interchange the side airbag sensor assembly LH with RH and connect the connectors.
Connect the cable to the negative (-) auxiliary battery terminal.
Clear the DTCs stored in memory Click here.
Turn the power switch off.
Turn the power switch on (IG), and wait for at least 60 seconds.
Check for DTCs Click here.
Result | ||||||||
---|---|---|---|---|---|---|---|---|
|
Tech Tips
Codes other than DTCs B1620/21 and B1625/22 may be output at this time, but they are not related to this check.
Turn the power switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Return the side airbag sensor assembly LH and RH to their original positions and connect the connectors.
*1 | Side Airbag Sensor Assembly RH |
*2 | Airbag Sensor Assembly |
B |
REPLACE SIDE AIRBAG SENSOR ASSEMBLY LH Click here |
C |
USE SIMULATION METHOD TO CHECK Click here |
A |
REPLACE AIRBAG SENSOR ASSEMBLY Click here