RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
Start up the engine.
A/C switch is ON.
Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Using SST, discharge the refrigerant gas.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE ROOF HEADLINING ASSEMBLY
REMOVE REAR NO. 5 ROOF AIR DUCT
Detach the 2 clamps.
Remove the 2 clips and rear No. 5 roof air duct.
REMOVE REAR NO. 4 ROOF AIR DUCT
Remove the 3 clips and rear No. 4 roof air duct.
REMOVE REAR NO. 3 ROOF AIR DUCT
Remove the 3 clips and rear No. 3 roof air duct.
REMOVE REAR NO. 2 ROOF AIR DUCT
Remove the 2 clips and rear No. 2 roof air duct.
REMOVE REAR NO. 1 ROOF AIR DUCT
Remove the 3 clips and rear No. 1 roof air duct.
REMOVE REAR NO. 1 SIDE AIR DUCT
Remove the 2 clips.
Detach the 2 claws and remove the rear No. 1 side air duct.
REMOVE REAR BUMPER COVER
REMOVE QUARTER VENT DUCT ASSEMBLY RH
Detach the 5 claws and remove the quarter vent duct assembly RH.
DISCONNECT NO. 1 COOLER COVER
Remove the packing.
Remove the 2 bolts and disconnect the No. 1 cooler cover.
DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Remove the 2 bolts.
Disconnect the air conditioning tube and accessory assembly.
Note
Do not use a screwdriver or similar tool to disconnect the tube.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
Remove the 2 O-rings from the air conditioning tube and accessory assembly.
REMOVE REAR COOLING UNIT ASSEMBLY
*1 | Bolt A |
*2 | Bolt B |
Remove the bolt labeled A and body ground.
Detach the 4 clamps.
Disconnect the 4 connectors.
Remove the 3 bolts labeled B and rear cooling unit assembly.