INSTALL STARTER ASSEMBLY
Install the starter with the 2 bolts.
Connect the starter wire with the nut and close the terminal cap.
Connect the starter connector.
INSTALL NO. 3 AIR HOSE
Note
Before installation, remove any oil residue from the inside of the pipe and hose.
*1 | Embossed Mark |
*2 | Paint Mark |
*a | Rear |
*b | RH Side |
Align the paint mark of the No. 3 air hose with the embossed mark of the throttle body.
Align the paint mark of the No. 3 air hose with the embossed mark of the No. 2 air tube.
Tighten the clamp of the No. 3 air hose on the diesel throttle body side.
Tech Tips
Align the paint mark of the air hose with the embossed mark and push on the air hose so that distance B is 0 to 2 mm (0 to 0.0787 in.).
Position the clamp so that distance A is 4 to 9 mm (0.157 to 0.354 in.).
Tighten the clamp of the No. 3 air hose on the No. 2 air tube side.
Tech Tips
Align the paint mark of the air hose with the embossed mark and push on the air hose so that distance B is 0 to 2 mm (0 to 0.0787 in.).
Position the clamp so that distance A is 9 to 15 mm (0.354 to 0.591 in.).
CONNECT NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY
Connect the No. 2 vacuum transmitting hose.
INSTALL BATTERY CARRIER
Install the battery carrier with the 4 bolts.
Attach the 2 clamps to connect the wire harness.
INSTALL BATTERY TRAY
INSTALL BATTERY
INSTALL BATTERY CLAMP SUB-ASSEMBLY
Attach the hook of the battery clamp to the battery carrier.
Partially tighten the nut and temporarily install the bolt.
Adjust the battery clamp position.
Tighten the nut and bolt.
INSTALL RADIATOR SUPPORT OPENING COVER
Install the radiator support opening cover with the 7 clips.
INSTALL NO. 1 ENGINE COVER
Attach the 4 clips to install the No. 1 engine cover.
CONNECT CABLE TO POSITIVE BATTERY TERMINAL
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.